multiquip

The BPX is Multiquip's backpack concrete vibrator motor, a swivel-mounted 2.1 HP Honda GXH50 four-stroke engine carried on a padded harness with th...

The EM120HYD is Essick's 12 cu ft towable plaster and mortar mixer on a hydraulic drive with a hydraulic dump, turned by an 11.7 HP Honda GX390 and...

The EM12M is Essick's 12 cu ft towable plaster and mortar mixer on a mechanical gearbox drive, turned by an 11.7 HP Honda GX390UT and carrying a 9-...

The EM70-Series is Essick's 7 cu ft steel-drum plaster and mortar mixer, built on a 10-gauge drum with a V-belt drive and a manual dump at a 21 in ...

The EM90-Series is Essick's 9 cu ft steel-drum plaster and mortar mixer, running a 10-gauge drum on a V-belt drive with an idler wheel for paddle e...

The G55H is Multiquip's stationary concrete vibrator power source, a 4.8 HP Honda engine on a base that swivels through 360 degrees so the shaft ca...

The Multiquip GDP5HANC2 is a portable generator that produces 180 Hz and 60 Hz power at the same time, so one machine runs high-cycle concrete vibr...

The Multiquip GloBug GB3LED is a 300 W LED balloon light on a three-stage tripod stand with gas-assisted lift. It diffuses light in every direction...

The Multiquip GloBug GB3LEDB is the 300 W LED diffused balloon lamp assembly on its own, without a mast, cart or stand. It is ordered as a replacem...

The Multiquip GloBug GB3LEDC pairs the 300 W diffused balloon light with a heavy-duty four-wheel cart that carries a portable generator. The cart p...

The Multiquip GloBug GB43LED is a four-wheel cart-mounted 4-spot LED light tower. Four 300 W LED lamps produce 152,000 lumens, standard outriggers ...

The Multiquip GloBug GB8LED is an 800 W LED diffused balloon light on a three-stage air-assisted pentapod stand. It reaches 110,000 lux at full out...

The Multiquip GloBug GBBAT3S4M is a cart-mounted 4-spot light tower that runs on lithium-ion batteries rather than an engine, so it lights a site w...

The Multiquip GloBug GBBAT8BM is a cart-mounted balloon light tower that runs on lithium-ion batteries rather than an engine, so it lights a site w...

The Multiquip GloBug GBC8LED pairs the 800 W diffused balloon light with a steerable industrial cart that carries a portable generator. The cart se...

The Multiquip GloBug GBHM is a hitch mount kit that fixes a GloBug balloon lamp assembly to a vehicle towing hitch. It supplies the bracket, two al...

The Multiquip GloBug GBMP is a mounting plate kit that fixes a GloBug balloon lamp assembly to a flat vertical surface. It supplies the plate, two ...

The Multiquip GloBug GBX12SK is a towable 4-spot LED light tower on a DOT-approved trailer. Four 300 W LED lamps on a multi-sectional aluminium mas...

The Multiquip GloBug GBX24BK is a towable balloon LED light tower on a DOT-approved trailer. A single 2,400 W LED balloon lamp on a multi-sectional...

The HBC-Series are handheld electro-hydraulic rebar cutters that shear bar on the deck instead of sending it to a torch or a saw. Both run on 115 V...

The MB25A is a bench-type rebar bender that takes bar up to 1 in through a 0 to 180 degree bend in about five seconds, driven by a 115 V single-pha...

The Multiquip MTe55B is a battery tamping rammer for zero-exhaust, low-noise compaction of cohesive and mixed backfill. It runs a Honda GXE2.0S, DC...

The Multiquip MTR40HF is a gasoline tamping rammer for compacting cohesive and mixed backfill in trenches and confined areas. It runs a Honda GX100...

The Multiquip MTX-Series rammers are gasoline tamping rammers for compacting cohesive and mixed backfill in trenches and confined areas. The lineup...